Send documentation comments to mdsfeedback-doc@cisco.com
C-7
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
Appendix C Cable and Port Specifications
MGMT 10/100 Ethernet Port
Figure C-4 shows a schematic of the 10/100BASE-T cable required to connect the management port to
a switch or hub (not provided with the switch).
Figure C-4 Twisted-Pair 10/100BASE-T Cable Schematic
Supported Power Cords and Plugs
Each power supply has a separate power cord. Standard power cords or jumper power cords are available
for connection to a power distribution unit having IEC 60320 C19 outlet receptacles. The jumper power
cords, for use in cabinets, are available as an optional alternative to the standard power cords.
Power Cords
The standard power cords have an IEC C19 connector on the end that plugs into the switch. The optional
jumper power cords have an IEC C19 connector on the end that plugs into the switch, and an IEC C20
connector on the end that plugs into an IEC C19 outlet receptacle.
Note Only the regular power cords or jumper power cords provided with the switch are supported.
Table C-8 lists the power cords for the Cisco MDS 9200, 9100, and 9020 series of switches and provides
their lengths in feet and meters.
1 TXD+
2 TXD-
3 RXD+
6 RXD-
1 RXD+
MGMT 10/100
Switch/Hub
2 RXD-
3 TXD+
6 TXD-
4NC
5NC
7NC
8NC
4NC
5NC
7NC
8NC
99343
Table C-8 Power Cords for the MDS 9200, 9100, and 9020 Series of Switches
Description
Length
Feet Meters
Power Cord, 125 VAC 13 A NEMA 5-15 Plug,
North America
8.2 2.5
Power Cord, 250 VAC 10 A 3112 Plug,
Australia
8.2 2.5
Power Cord, 250 VAC 10 A CEE 7/7 Plug,
EU
8.2 2.5
