A SERVICE OF

logo

Send documentation comments to mdsfeedback-doc@cisco.com
C-6
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
Appendix C Cable and Port Specifications
MGMT 10/100 Ethernet Port
MGMT 10/100 Ethernet Port
The MGMT 10/100 Ethernet port is an Ethernet port with an RJ-45 connector. You can use a modular,
RJ-45, straight-through UTP cable to connect the management port to an external hub, switch, or router
(see Figure C-3).
Figure C-3 RJ-45 Interface Cable Connector
Table C-7 lists the connector pinouts and signal names for a 10/100BASE-T management port (MDI)
cable.
Note The RJ-45 interface only uses pins 1, 2, 3, and 6.
1 Pin 1 2 Pin 8
94971
1
2
RJ-45 (both ends)
Table C-7 10/100BASE-T Management Port Cable Pinout (MDI)
Pin Signal
1TD+
2TD-
3RD+
6RD
4Not used
5Not used
7Not used
8Not used