12-23
Cisco TelePresence System 3200
OL-14521-01
Chapter 12 Field-Replaceable Unit Guide
Replacing a First Row Table Top Section
Note Make sure that the leg still supports both table top sections.
Step 8 Remove the draw bolts between the table top sections on the side that you moved. See Chapter 6,
“Building the First Row Table Assembly” for the location of the draw bolts.
Step 9 If required, reposition the table leg so that it fully supports both table sections.
Step 10 Move the table leg on the other side of the table top to allow access to the draw bolts, making sure that
the leg still supports both table top sections.
Step 11 Remove the draw bolts between the table top sections on the side that you moved.
Step 12 Separate the table top sections to create a space between the section to be replaced of approximately one
inch (2.5 centimeters); this step allows you to remove the splines between the table top sections.
Tip Move the sections to the left and use the space created by the open table door.
Caution Be sure that the legs support all table top sections and do not allow any of the sections to fall.
Step 13 Remove the splines from the slot in the edges of the table top section.
Step 14 Remove the table top section from the table legs.
Step 15 Place the new table top section on the table legs.
Step 16 Place the splines in the slots on the edge of the new table top section.
Step 17 Press the table top sections together.
Step 18 Insert the draw bolts and tighten them between the new table top section and the adjoining table top
sections. See Chapter 6, “Building the First Row Table Assembly” for the location of the draw bolts.
Step 19 Attach the legs to the table top sections with the screws. See Chapter 6, “Building the First Row Table
Assembly” for the location of the table legs and screw attachment locations.
Step 20 Reconnect the microphone to the new table top section.
Step 21 Route the microphone cable to the audio/video extension unit and connect the cable to the unit.
See Figure 6-13 for microphone installation instructions.
Step 22 Close the table door.
Step 23 If you removed the table door, replace the door.
See Figure 6-14 for table door installation instructions.
