The View Administration Option
Issue 6 February 2007 141
Call server nnn.nnn.nnn.nnn.nnnnn Up to 21 ASCII characters: IP
Address and port of call server
currently in use, if any, otherwise
“0.0.0.0”.
802.1X pass-thru mode
pass-thru with Logoff
Supplicant mode
If system parameter DOT1X = 0
If system parameter DOT1X = 1
If system parameter DOT1X = 2
Group nnn Up to 3 ASCII numeric characters:
GROUP.
Protocol cccccccc
filename.ext
ccccccc Ethernet
filename.ext
cccccccccc
cccccccccc
Up to 8 ASCII characters, depending
on the system-specific signaling
protocol (H.323, SIP, etc.) currently
being used.
Up to 16 ASCII characters: name of
the application code file (“big app”)
currently stored in the telephone.
Ethernet connection. From 2 to 7
ASCII characters, either “100Mbps,”
“10 Mbps,” or “No.”
Up to 16 ASCII characters. Name of
the boot code file (“little app”)
currently stored in the telephone.
Up to 10 ASCII characters. DSP
code version.
Up to 10 ASCII characters. DSP
hardware version, displayed only if a
DSP hardware version identifier is
available.
Build cccccccccc Build identifier. Up to 10 ASCII
characters.
DHCPSTD DHCP standard flag. If “1,” the
telephone strictly follows the DHCP
standard by giving up IP Addresses
when the DHCP lease expires. If “0,”
the telephone uses the IP Address
until it detects reset or a conflict
Table 15: Viewing Parameter Values (continued)
Name System Value Format
2 of 3
