Filter
Top Products
Radio And Buzzer Operation
You may set one alarm for wake to RADIO and the other for wake to BUZZER. Just set the ALARM 1 and ALARM 2 Selector
Controls to the desired positions.
Snooze Control
After the alarm turns on in the morning you may press the Snooze button to stop the alarm for 9 minutes. After 9 minutes
the alarm turns on again.
The Snooze operation may be repeated several times within one hour of the original alarm time. But after one hour the alarm
will not turn on again.
During Snooze operation the appropriate Alarm indicator flashes in the display.
Sleep To Music or Soothing Sounds Timer
You can program the Sleep Timer to play the radio or soothing sounds from 1 minute up to 99 minutes and then shut off
automatically.
1. Press the SLEEP button. The display will briefly show “60” and the radio will begin to play.
After 60 minutes the radio will shut off automatically. Each time you press the SLEEP button
the sleep timer will start at 60 minutes. This is the initial sleep timer default setting.
2. To increase or decrease the amout of time that the radio will play before shutting off, hold the sleep button and press
either the SET “+” or “ – ” buttons to change the display to the desired sleep time, up to a maximum of “99” minutes or
a minimum of “1” minute.
Note: When you change the sleep timer from the 60 minute default setting to a different setting, the new setting becomes
the new default setting. Whenever you activate the sleep timer it will begin with your new default setting and count down to
zero from that point.
3. To cancel the sleep timer before it counts down to “0” and shut the radio ‘Off’ immediately, press the SNOOZE bar.
IMPORTANT: Remember the that radio station or soothing sound, and volume level that you select for the “Sleep To Music”
operation are the same settings that you will hear if you set the alarm for wake to radio the following morning.
Display Dimmer Control
You can reduce the display brightness by sliding the DIMMER control to the Low position.
Projector Operation
IMPORTANT: The projected image will be most visible when the
room is dark. The image may not be visible during daylight hours
or in a brightly lit room.
1. Press the PROJECTOR ON/OFF button to turn the projector ‘On’.
2. Turn the projector housing slowly to aim the projected image on your
wall or ceiling.
10
“PROJECTOR” On/Off Button