Filter
Top Products
5
POWER CONTROL
DISPLAY DIMMER
Your radio features an automatic display dimmer.
When the light level in your room drops at night, the display
brightness will automatically dim to compensate.
When the light level in your room rises, the display will
automatically brighten.
NOTE: The display brightness sensor is on the top panel of
your unit. Do not place any items on top of the unit or the
display will be permanently dim.
GETTING STARTED
DAB/FM AERIAL
Before using your radio for DAB or FM reception, unwrap
and fully extend the aerial wire. You may need to adjust the
position of the aerial wire for maximum signal strength.
SETTING THE CLOCK
The clock on your radio is automatically set when rst used
from the time signal broadcast with DAB radio stations. To set
the clock it will be necessary to tune to a DAB station. The
clock will automatically update.
The clock is not set by the user.
INITIAL SCAN
When your radio is used for the rst time:
The radio scans all usable stations (full scan) and stores them
alphanumerically - 1 Radio, 2 Radio, AA Radio, AB Radio...
The initial scan will take a few minutes. After the scan, the
number of stations found will be displayed, the clock will be
set, the radio will display the rst station in the sequence and
begin playing at the default system volume of 10.
Note: If no stations are found after the scan, ‘0 Services Found’,
then ‘Service N/A’ will be displayed. If this happens, switch
the radio o and move it to a location with a stronger signal.
When you switch the radio back on it will automatically
repeat the scan process.
To increase the volume:
Rotate the • VOLUME/SELECT control wheel toward the
back of the unit.
To decrease the volume:
Rotate the • VOLUME/SELECT control wheel toward the
front of the unit.
NOTE: Two clicks of the wheel will increase/decrease the
volume by one step.
AUTO DISPLAY DIMMER
CONNECTING POWER
Check that the mains voltage marked on the rating plate •
on the underside of the unit is the same as the voltage
in your area.
Plug the mains plug into the wall socket and switch the •
mains power on.
STANDBY CONTROL
To turn the radio on:
Press the • STANDBY/ON button.
The display will light and the radio will tune to the last station
used. If the power has been disconnected, the clock will set.
To turn the power o:
Press the • STANDBY/ON button.
The radio and display light will switch o. The clock will
continue to run whilst mains power is connected.
ADJUSTING THE VOLUME
SELECTING A DAB STATION
The stations are stored in an alphanumeric list.
To select another station
Press the • JOG MODE/SELECT button to switch to tuning
mode.
‘Station list’ appears on the display.
Turn the • VOLUME/SELECT control wheel to browse
through the list of station names on the display. Two
clicks of the wheel will change to the next/previous
station in the list.
When you nd the station name you want to listen to, •
press the JOG MODE/SELECT button.