Filter
Top Products
12 TASCAM CD-RW901MKII
2 − Features of the CD-RW901MKII
Display
@
DF G H JK
$ & * ( ) Q E
Y
U
I
O
P
A
W%#
S
^
R
T
This display shows various types of operation information,
including CD disc information, deck operation modes, and
menu status.
@ TOC The TOC indicator lights up red when a loaded disc
contains TOC (Table of Contents) data.
# Track number display During playback or selection,
the track number is displayed.
When Incremental playback is on, and when in play-
back or playback ready mode, the TRACK indicator blinks.
$ MP3 The MP3 indicator lights when a MP3 disc is in
the deck.
% Counter display Depending on the time display mode,
TOTAL or REMAIN are lit. The counter display indication
are in minutes (three digits) and seconds (two digits).
^ KEY The KEY indicator lights when Key Control is on.
& PITCH The PITCH indicator lights when Pitch Control is on.
* A.CUE The A.CUE indicator lights when Auto Cue is on.
( A.READY The A.READY indicator lights when Auto
Ready is on.
) A. TRACK The A.TRACK indicator lights when the Auto
Track is on.
Q Meter This displays the playback level, as well as the
input level of the source device.
W A-B The A-B indicator lights when the A-B repeat func-
tion is on.
Also, this flashes until a “B-point” is entered.
E REPEAT The REPEAT indicator lights when the Repeat
function is on.
R SYNC The SYNC indicator lights up when SYNC is on.
T REC When the SRC function is on, this lights during
recording, or in recording standby mode.
When the SRC function is off, this flashes during
recording, or in recording standby mode.
Y OPTICAL The OPTICAL indicator lights when the input
source is set to optical.
U COAXIAL The COAXIAL indicator lights when the input
source is set to coaxial.
c DIGITAL IN/OUT (AES/EBU) These two XLR connec-
tors accept and output digital audio in standard profes-
sional format.
v ANALOG INPUT (BALANCED) (L, R) These XLR
connectors accept analog audio signals at +4 dBu from
suitably-equipped units.
The wirings are: 1=grounding, 2=hot, 3=cold.
bm ATT control right and left Use a small Phillips
screwdriver with these attenuators to reduce the output
level from either the right or left balanced analog
output. The adjustable level is up to -10 dB.
n ANALOG OUT (BALANCED) (L, R) These XLR
connectors output analog audio signals at +4 dBu to
suitably-equipped units.
The wirings are: 1=grounding, 2=hot, 3=cold.
,
CONTROL I/O (RS-232C) terminal RS-232C compati-
ble serial control from an external PC can be performed.
.
CONTROL I/O (parallel) terminal Use this
15-pin D-sub connector to connect the unit to
suitably-equipped units, allowing control of the
CD-RW901MKII. The pinouts of this connector are
described (see Connections” on page 9).
/
REMOTE IN terminal Connects the supplied
RC-RW901 remote control unit.
!
AC IN jack Connects the power cable supplied.