Filter
Top Products
Scanning The Tracks
You can set the CD player to play the first 10 seconds of each track on
the loaded CD, so you can find the track you want to hear.
To begin scanning, press 3 INTRO. INTRO appears during scanning. Press 3
INTRO again to resume normal play. INTRO disappears.
Program Play
Your CD player can store up to 10 tracks in memory for programmed
playback.
1. For each track you want to store, repeatedly press < or > to select
the track, then hold down 5 P.MEM for more than 2 seconds. A program
memory number (P 1-P 10) flashes.
2. Press 5 P.MEM within 4 seconds to store the track in memory.
3. to start program play, press 6 P.PLAY. The player begins playing back
the tracks stored in memory. The current memory number appears.
Note: During programmed play, P and the program number memory appear.
Press DISP to see the elapsed time and track number. Within 4
seconds, press DISP again to see the current time for about 4
seconds.
4. To clear the programmed memory, hold down P.CL (PS/AS) for more than 2
seconds. CLr flashes. Press P.CL (PS/AS) again within 4 seconds to
clear all memories.
Auxiliary Input
You can connect an external auxiliary signal source (such as a portable
mini-disc player or cassette player) to the AUX input jack in the bottom
right corner of the front panel, using an optional audio cable (available
at your local RadioShack store) with a 1/8 inch (3.5 mm) plug.
Plug the other end of the audio cable into the output jack of the audio
source, then press MODE until AUX appears. Adjust the volume, bass,
treble, balance an fader controls to the desired level.
Switching Between Modes
You can temporarily stop a CD and listen to the radio or a connected