Sony MZ-R501 Portable CD Player User Manual


 
36
Messages
If the following error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
BLANK An MD with no recording on it is inserted.
, Insert a recorded MD.
BUSY You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take
23 minutes).
Edit The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the
player to physical shock, nor disrupt power supply.
ERROR The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. If this fails, rerecord.
FULL There is no more space to record on the disc (less than 12
seconds in stereo, 24 seconds in LP2 stereo mode or monaural
or 48 seconds in LP4 stereo mode available).
, Replace the disc.
You tried to enter more than 200 letters to label a single track
or disc.
You tried to enter a total of more than 1,700 letters for track or
disc names during playback or stop.
, Enter a shorter name for track or disc, or delete LP: from
the beginning of the track name recorded in MDLP mode
(page 26).
HiDCin Voltage of the power supply is too high (The recommended
AC power adaptor is not used).
, Use the recommended AC power adaptor.
HOLD The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 25).
LoBATT Battery is weak.
, Replace the dry battery (page 9).
MEMORY You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording
again.