Filter
Top Products
21
5 While observing the level meter in the
display, adjust the recording level by
pressing SELECT >/..
Set the level so that the maximum
input lights up the fifth segment on
the level meter. If the sixth segment
lights up, lower the level by pressing
SELECT >.
Recording does not start in this step.
If your source is an externally
connected component, be sure to cue
the source to the beginning of the
material to be recorded before you
start playback.
6 Press X again to start recording.
To stop recording
Press x.
The recording level control is switched back to
automatic control when you record the next
time.
Notes
• The recording level cannot be adjusted while
recording is in progress. If you want to adjust
the recording level after you have started the
recording, press X to pause the recorder. Then
do the procedure from step 5.
• You cannot adjust the recording level
manually during synchro-recording.
Checking the remaining
time or the recording
position
You can check the remaining time, track
number, etc. when recording or during
stop.
1 While the recorder is recording or
stopped, press MENU/ENTER, press
SELECT >/. repeatedly until
“DISP” flashes in the display, and
then press MENU/ENTER again.
2 Press SELECT >/. repeatedly
until the information you want flashes
in the display.
Each time you press SELECT .,
the display changes as follows.
LapTim (elapsed time)
r
RecRem (remaining time for
recording)
1)
r
AllRem (remaining time after the
current location)
1)
“RecRem” start flashing in the
display when the remaining time for recording
become 3 minutes or less.
fifth segment
SELECT >/.
MENU/ENTER
continued