18
To start/stop recording
in sync with the source
player
(Synchro-recording)
You can easily make digital recordings of
a digital source on an MD.
Before synchro-recording, make
connections to the digital source with a
digital cable, and insert a recordable MD.
1 Press MENU/ENTER while the
recorder is stopped.
2 Press SELECT >/. repeatedly
until “SYNC-R” flashes in the
display, and then press MENU/
ENTER.
“SYNC” lights up in the display.
“SYNC” does not lights up if optical
cable is not connected to the recorder.
3 Press SELECT >/. repeatedly
until “ON” flashes in the display, and
then press MENU/ENTER.
4 Press N while pressing REC.
The recorder stands by for recording.
5 Play the source sound.
The recorder starts recording when it
receives the playing sound.
To stop recording
Press x.
z
• You cannot pause manually during synchro-
recording.
• When there is no sound from the player for
more than 3 seconds during synchro-
recording, the recorder goes into the standby
mode automatically. When the sound comes
from the player again, the recorder resumes
synchro-recording. If the recorder is kept in
the standby mode for 5 minutes or longer, the
recorder stops automatically.
• For longer recording, follow steps 1 to 3 of
“Recording for long times” (page 16) to select
the recording mode, and then start the
procedure of synchro-recording.
Notes
• Do not change the “SYNC-R” setting while
recording. Recording may not be done
properly.
• Even when there is no recorded sound on the
sound source, there may be cases when
recording does not pause automatically during
synchro-recording due to the noise level
emitted from the sound source.
• If a silent portion is encountered for 2 seconds
or more during synchro-recording, a new track
mark is automatically added at the point
where the silent portion ends.
• Synchro-recording cannot be done if the
connecting cord is not an optical cable.
• You cannot adjust the recording level
manually during synchro-recording.
CD players,
etc.
N
REC
SELECT
>/.
MENU/ENTER
SYNC indication