Filter
Top Products
43
Connecting to a stereo system
Connect the i jack of the recorder to the LINE IN jacks of an
amplifier or a tape recorder with a line cable (RK-G129 or RK-G136,
not supplied). The output is analog. The recorder plays the MD
digitally and sends analog signals to the externally connected
equipment.
When the recorder is connected to an another
audio component through the supplied remote
control.
When connecting a line cable (not supplied) to the i jack of the
remote control, be sure to set the “BEEP” setting to “BEEP OFF.”
This keeps the beep sound out of the recorded signal or the output
from the externally connected equipment.
1 Press ENTER, press <MENU, repeatedly until “BEEP”
flashes in the display, and then press ENTER again.
2 Press <MENU, repeatedly until “BEEP OFF” flashes in the
display, and then press ENTER.
RK-G136
(not supplied)
Stereo
mini-plug
Portable DAT
recorder, etc.
Stereo system,
etc.
to LINE IN
R (red)
L (white)
2 phono plugs
RK-G129
(not supplied)
to i