Filter
Top Products
30
2 Press <MENU, repeatedly until “SYNC REC” flashes in the
display, and then press ENTER.
“SYNC” does not appear if optical cable is not connected to the
recorder.
3 Press <MENU, repeatedly until “SYNC ON” flashes in the
display, and then press ENTER.
4 Press and slide REC to the right.
The recorder stands by for recording.
5 Play the source sound.
The recorder starts recording when it receives the playing sound.
To stop recording, press x.
z
•You cannot pause manually during synchro-recording.
•When there is no sound from the player for more than 3 seconds during
synchro-recording, the recorder goes into the standby mode automatically.
When the sound comes from the player again, the recorder resumes synchro-
recording. If the recorder is kept in the standby mode for 5 minutes or longer,
the recorder stops automatically.
•For longer recording, follow step 1 of “Recording for long times” (page 28)
to select the recording mode, and then do the procedure of synchro-
recording.
Notes
•Do not change the “SYNC REC” setting while recording. Recording may not
be done properly.
•Even when there is no recorded sound on the sound source, there may be
cases when recording does not pause automatically during synchro-recording
due to the noise level emitted from the sound source.
•If a silent portion is encountered for 2 seconds or more during synchro-
recording from a sound source other than a CD or an MD, a new track mark
is automatically added at the point where the silent portion ends.
SYNC REC
SYNC indicator