Filter
Top Products
The Timer
CFD-ZW150/.ZW160/ZW200.E_3-859-373-1X.U2/CA2/AU6
18
Waking up to music (continued)
Tips
• The display window
dims while the waking
up timer is on.
• You can have the
player go on the next
day at the same time.
Just press STANDBY
until the t indication
appears in the display.
The preset settings
remain until you reset
them.
Note
During the timer
mode, you cannot
change the tape player
to the tape function.
To operate the tape
player, press
STANDBY until the t
indication disappears
from the display first,
then operate the tape
player.
6 Press STANDBY.
The t indication appears in the display and the
power goes off.
At the preset time, the power will go on and music
will play for 2 hours.
To check/change when the playback will start
Press TIMER for about 2 seconds, then DISPLAY/
ENTER. Each time you press DISPLAY/ENTER, a
stored setting lights up. Change the setting if you need
to when the setting lights up. When you finish
checking the setting of volume, press TIMER again.
To use the player before a timer playback starts
Just turn on the player, and then you can use it.
If you turn off the player before the preset time, timer
playback will start at the preset time.
In case of the radio, however, if you listen to the
station which is different from the one you tuned in
in step 1 on page 17, you will hear that station at the
preset time. Make sure to tune in the station you want
to listen to before you turn off the player.
To stop play
Press POWER.