94
Appendix
• No power
• Unit cannot be operated.
• Remote control unit does not
operate.
• Picture is cut off/with sidebar
screen.
• Strange color, light color, or color
misalignment
• Power is suddenly turned off.
• No picture
• No sound
Problem Possible Solution
• Make sure the Display and the AVC System are connected correctly. (See page
XX.)
• Check if you pressed TV POWER on the remote control unit. (See page XX.)
If the indicator on the Display lights up red, press POWER on the Display.
• Is the AC cord disconnected? (See page XX.)
• Has the main power been turned on? (See page XX.)
• External influences such as lightning, static electricity, may cause improper
operation. In this case, operate the unit after first turning on the power of the
Display and the AVC System, or unplugging the AC cord and replugging it in
after 1 or 2 minutes.
• Is the Mode switch set correctly? Slide it to the TV setting position.
• Are batteries inserted with polarity (e, f) aligned? (See page XX.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
• Is a fluorescent light illuminated near the remote control sensor?
• Is the image position correct? (See pages XX and XX.)
• Are screen mode adjustments such as picture size made correctly? (See pages
XX and XX)
• Adjust the picture tone. (See pages XX to XX.)
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the input signal setting. (See page XX.)
• Is the sleep timer set? (See page XX.)
• Check the power control settings. (See pages XX and XX.)
• The unit’s internal temperature has increased.
Remove any objects blocking vent or clean.
• Is connection to other components correct? (See pages XX to XX.)
• Is correct input signal source selected after connection? (See page XX.)
• Is the correct input selected? (See page XX.)
• Is a non-compatible signal being input? (See page XX.)
• Is picture adjustment correct? (See pages XX to XX.)
• Is “On” selected in “Audio Only”? (See page XX.)
• Is the volume too low? (See page XX.)
• Is “Variable” selected in “Output Select”? (See page XX.)
• Is correct speaker output (“Speaker-A” or “Speaker-B”) selected in “Speaker”?
(See pages XX and XX.)
• Is “On” selected in “Center Channel Input”? (See page XX.)
Troubleshooting
Cautions regarding use in high and low temperature environments
• When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly
delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight or near
a heater, as this may cause the cabinet to deform and the Liquid Crystal panel to malfunction.
Storage temperature: –4°F to +140°F (–20°C to +60°C)