Filter
Top Products
Setting the clock
1. The clock will start running when the batteries are installed or
when the radio is connected to the mains supply. The display
will show 0:00 (PR-D2) or 12:00 (PR-D2V).
2. Ensure that the radio switched off.
3. Press the Band (Time Set/ST. MO.) button, the hours digits will
flash in the display followed by a beep sound.
4. Press Tuning up/down button to set the required hours.
5. Press the Time Set button, the minute digits will flash in the
display.
6. Press the Tuning up/Down buttons to set the required minute.
7. Press the Time Set button to complete time setting.
Operating the radio
Your radio is equipped with four tuning methods-Scan tuning,
Rotary tuning, Manual tuning and Memory preset tuning.
Scan tuning
1. Press the Power button to turn on the radio.
2. Select the required waveband by repeatedly pressing the Band
button. For the FM/TV(PR-D2V) band fully extend the
Telescopic aerial and set it at an angle of 45 degrees.
3. Press and hold down either the Tuning up or Tuning down
buttons for more than 0.5 seconds to commerce scan tuning.
4. The radio will scan selected waveband and stop automatically
when it finds a station of sufficient strength. The tuning indicator
will appear in the display.
5. To recommence scan tuning, press and hold down either the
Tuning up or Tuning down buttons for more than 0.5 seconds.
6. When the waveband end is reached, the radio will beep and
continue tuning from the opposite waveband end.
7. Rotate the Volume control clockwise to increase the volume and
anticlockwise to decrease the volume. Set the Tone control to
the desired setting.
8. To turn off the radio press the Power button.
6
GB