Filter
Top Products
NOTE: Signals to the LINE IN will be amplified only when the LINE
switch on the front panel is depressed to its on position.
3.
AUX/CD IN
The AUX/CD IN jacks accept audio signal input from any external
CD or CD ROM player, stereo receiver, audio mixer, video board or
VCR.
NOTE: Signals to the AUX/CD IN will be amplified only when the
AUX/CD switch on the front panel is depressed to its in position.
4.
LINE OUT
The LINE OUT provides line level output of the LINE input, AUX/CD
input and MIC/INST. input signals, unaffected by the Master VOL-
UME Control, BALANCE Control or GRAPHIC EQUALIZER.
5.
SUB OUT MONO
Connect the SUB OUT MONO output to the line in of an additional
amplifier and subwoofer or powered subwoofer system. Since sub-
woofer signals are normally mono, only one cable is used between
the DA80 and the subwoofer system. The SUB OUT MONO has
been designed to provide +6dB of line level output gain for a sepa-
rated amplifier or self contained subwoofer system equipped with a
built-in amplifier.
CAUTION: Do not connect a non-amplified subwoofer speaker
directly to the DA80’s SUB OUT MONO output or the warranty will
be void. Damage may occur to the sub line level output circuitry.
NOTE: Plugging Headphones into the front panel headphone jack
will mute any signal to the SUB OUT MONO output as well as to the
SPEAKER OUTPUTS.
6.
FUSE
The fuse provides protection for the DA80. The fuse will blow if there
is an overload condition, high demand for power amplification or
extremely low speaker impedance. Replacement size is a standard
F3A miniature fuse (5mm x 20mm) for 115V systems or T2A for
230V systems. If a fuse continues to blow, please contact Samson
service at 1-800-3SAMSON (1-800-372-6766).
7.
AC INLET
Connect the supplied standard 3-pin “IEC” plug to the AC INLET.
CONTROLS AND FUNCTIONS
10
ENGLISH