Filter
Top Products
Getting Ready
29
Overview Getting Ready Recording Playback File Operation Computer Appendix
Connecting Headphones
or Speakers
Here’s how to listen to the playback
through headphones or speakers you’ve
connected.
MEMO
• No sound is played from the R-26’s
preview monitor when headphones or
speakers are connected to the PHONES
jack.
• Before switching the power on/o,
always be sure to turn the volume
down. Even with the volume turned
down, you might hear some sound
when switching the power on/o.
However, this is normal and does not
indicate a malfunction.
When using speakers
* Once the connections have been
completed , turn on power to your
various devices in the order specied. By
turning on devices in the wrong order,
you risk causing malfunction and/or
damage to speakers and other devices.
1. Minimize the volume of the speakers
you’ll be connecting, and turn o
their power.
2. Connect the speakers.
You’ll need to use speakers that have a
built-in amplier.
Use an audio cable to connect the R-26’s
PHONES jack to the line input jacks of your
speaker system.
3. Switch on the R-26’s power(p. 24).
4. Raise the R-26’s [VOLUME].
5. Switch on power to your speakers,
and gradually increase the volume to
an appropriate level.
* To prevent malfunction and/or damage
to speakers or other devices, always
turn down the volume, and turn o the
power on all devices before making any
connections.
* This unit is equipped with a protection
circuit. A brief interval (a few seconds)
after power up is required before the
unit will operate normally.
* Howling could be produced depending
on the location of microphones relative
to speakers. This can be remedied by:
1. Changing the orientation of the
microphone(s).
2. Relocating microphone(s) at a greater
distance from speakers.
3. Lowering volume levels.