Filter
Top Products
17
Manual tuning - FM
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press the On / Off control to switch on your clock radio.
3. Press and release the Mode button until the FM band is selected.
4. Repeatedly press and release the Tuning Up or Down buttons to
tune to a station. The frequency will change in steps of 50kHz.
If the radio is tuned to a station of suffi cient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Adjust the Volume to the required setting.
7. To switch off your clock radio, press the On / Off control.
Note:
If you fi nd that FM reception is poor, try repositioning the wire aerial. Fully
extend the wire aerial located on the rear of your clock radio. Place the
wire antenna so that it is as straight as possible extending either above or
below the radio. If you fi nd that an FM broadcast has a lot of background
hiss, this may often be reduced by setting the radio into Mono reception
mode for the current FM station. Please refer to the section "Stereo / Mono
setting - FM" on page 21 for further details.
2,7
3
44
6