Filter
Top Products
EN
7
Optional YM-8 and YM-8T Mounting Procedure (continued)
5- Strip the speaker wiring ends and connect the wires. If
using the YM-8, connect the wires directly to the binding
posts. If using the YM-8T, connect the 70V/100V terminals
in the cover assembly.
5a- The YM-8T cover assembly is equipped with the 70V/
100V matching transformer, a 4-position power selection
switch, and all required connections pre-wired. Just con-
nect the speaker wires to the appropriate terminals inside
the cover, then install the cover onto the loudspeaker. Cover-
to-loudspeaker connections are made by the banana plugs
in the YM-8T assembly.
7- Rotate the cabinet into the desired position and tighten
both of the mounting knobs.
6- Align the cover on the back of the
loudspeaker and slide into place. The cover is designed to
fit only one way. Install the cover retaining screw to prevent
the cover from vibrating loose and to keep the connections
weather-tight. Attach a safety cable to the attachment point
on the bottom-back of the loudspeaker. Ensure the safety
cable, cable attachment technique, securing hardware, and
attachment points are strong enough to support the weight
of the loudspeaker in the event of a primary-mount failure.
IMPORTANT! PLEASE READ AND ENSURE THAT THE LOUDSPEAKER IS MOUNTED PROPERLY AND A SAFETY
CABLE IS INSTALLED TO RETAIN THE LOUDSPEAKER IN THE EVENT OF A MOUNTING FAILURE.
Ensure the mounting surface and supporting structure are appropriately strong enough to support the loud-
speaker assembly and any potential vibration or seismic activity.
Attach a safety cable to the attachment point on the bottom-back of the loudspeaker. Ensure the safety cable,
cable attachment technique, securing hardware, and attachment points are strong enough to support several
times the weight of the loudspeaker in the event of a primary-mount failure.