Filter
Top Products
9
English
EN
3 Get started
Charge power
MIX has a built-in battery that can be charged
through the USB port of a computer.
As shown, connect the MIX to a PC.
Note
When you connect • MIX to a computer, you
are briefly prompted to select: [Charge &
transfer] or [Charge & play].
• MIX automatically applies [Charge & transfer],
if no new selection is made.
Battery level indication
The display indicates the approximate levels of
the battery status as follows:
100% 75% 50% 25% 0%
A flashing battery screen indicates »
that the battery is low. The player
saves all settings and switches off
within 60 seconds.
Note
Rechargeable batteries have a limited number •
of charge cycles. Battery life and number of
charge cycles vary by use and settings.
The charging animation stops and the
•
icon is displayed when the charging process is
completed.
To conserve battery power and increase the
play time, do the following on MIX:
Set the backlight timer to a low value •
(go to
> [Display settings] >
[Screen off timer]).
First-time setup
The first time you connect MIX to a PC, install
Philips Device Manager on the PC. Over the
Internet, you can update the firmware of the
player through Philips Device Manager.
When you connect the MIX to the PC for the
first time, a pop-up window appears:
1 Select InstallPhilips Device Manager.
2 Follow the on-screen instructions to
complete the installation of the software.
Note
The installation requires you to agree to the •
license terms.
If the pop-up window is not displayed
automatically:
1 Select My Computer (Windows XP /
Windows 2000) / Computer (Windows
Vista / Windows 7).
2 Right click on the Philips GoGear MIX
icon.
3 Select Install Philips Device Manager.
4 Follow the on-screen instructions to
complete the installation of the software.
Note
The installation requires you to agree to the •
license terms.