Filter
Top Products
6
IInnssttaalllliinngg tthhee ssppeeeedd aanndd ddiissttaannccee mmoonniittoorr
Use an appropriately-sized coin to twist
cclloocckkwwiissee
to open the speed
monitor battery door. Insert an AAA alkaline battery (with positive in first).
Replace the battery door, pressing fully in and twist
aannttii--cclloocckkwwiissee
to
secure the closing.
1
Press and hold 22;; for 2 seconds to power on your player.
Press
SSDDMM
for 2 seconds to power on the monitor. Your monitor will blink.
The monitor is now ready to record your running activities.
3
Unhook the rubber strap and detach the clip. Loosen shoelaces and slide
monitor clip under laces. Secure the monitor to your running shoe.
The monitor should rest just below where laces tie and be secure enough to
stay in place during running.
2
TBD
TBD
After running is completed, terminate the logging (see page 11).
Press and hold
SSDDMM
for 2 seconds to power off your monitor after use.
4
TIP
Batteries contain chemical substances, so they should be disposed of
properly.
Incorrect use of batteries can cause the electrolyte leakage and will
corrode the compartment or cuase the batteries to burst.
Remove the batteries if the set is not to be used for a long time.
✔
AATTTTEENNTTIIOONN
: Anyone beginning an exercise regimen for the first time
(especially users of pacemakers or other implanted devices) should
consult a physician or health professional before using the
MMPP33
RUN.
TIP
> Your SDM automatically shutdown when there is no connection with
your player for 10 minutes or no activity is detected for 30 minutes.
Press
SSDDMM
for 2 seconds to power on the monitor again.
> Replace the battery when your monitor blinks rapidly (usually after 50 hrs
for a high quality alkaline battery).
✔
TBD
2 SEC
TBD
PSA260-eng.qxd 7/15/04 12:39 PM Page 6