Filter
Top Products
20
English
Clock/Sleep Timer
Clock setting
The clock uses the 12-hour mode.
1 In standby mode, press PROG/CLOCK for
more than two seconds.
➜ The clock digits flash.
2 Press ALBUM/PRESET 3 4 to set the
minutes.
3 Press S/T to set the hours.
4 Press PROG/CLOCK to confirm the time.
Setting the Alarm Time
● Wake up to FM radio or music from your USB
device or iPod. The clock time needs to be set
first before the alarm clock can be used.
1 Press ALARM for more than two seconds to
enter the alarm setting mode.
➜ The alarm activated icon
appears.
➜ The alarm clock digits flash.
➜ "Error" appears briefly if you have not set the
clock time.
2 Press ALBUM/PRESET 3 4 to set the
minutes.
3 Press S/T to set the hours.
4 Press iPod, TUNER or USB/AUX to select
the sound source.
5 Press ALARM to confirm your alarm setting.
➜ The display returns to the clock time.
Notes:
The TUNER mode is the default source if:
–Your USB device contains no MP3 or WMA files.
–You forgot to connect a USB device.
–You forgot to dock your iPod.
Stopping the alarm
● To repeat the alarm at 9 minute intervals, press
REPEAT ALARM on the set.
➜ You can repeat this up to a maximum of 6
times consecutively. Your alarm will then stop
and reactivate at the same time next day.
● To cancel the alarm before the set time, press
ALARM in standby or playback mode.
➜ Display shows if activated, and disappears if
deactivated.
● To select the 24-hour reset alarm option, during
the alarm call press STANDBY-ON2. The
alarm will reactivate at the same time next day.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1 Press SLEEP on the remote control repeatedly
to select a preset time.
➜ The selections are as follows (time in
minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF…
➜
is displayed.
2 To review the remaining sleep time, press
SLEEP .
pg001-025_DC199_37-Eng 2007.11.22, 15:5220