Filter
Top Products
Packard Bell Vibe 100 Disassembly Manual
7
2. Disconnect the flat cable from the hard disk. To do so, lift up the
dark-coloured clip and pull out the flat cable.
Fig. 4 The flat cable connector
3. Remove the rubber placeholders, and place them on the new hard
disk.
4. Reconnect the flat cable:
push in the cable, and push down the clip
to secure the cable.
Removing the Mainboard/LCD assembly
To remove the mainboard, open the player (see Opening the Casing
),
remove the battery (see Removing the Battery
) and perform the following
steps:
1. Lift up the mainboard to reach the HDD flat cable connector.
2. Lift up the tape covering the HDD connector.
3. Now push down the two clips on the side of the connector.
4. Take out the flat cable.