Filter
Top Products
2
Packard Bell Vibe 100 Disassembly Manual
Overview
This document contains step-by-step disassembly instructions for the Vibe 100 MP3
player. The instructions are illustrated where necessary with images of the part that is
being removed or disassembled. Furthermore, the screws that are removed are shown
next to the image of the parts themselves.
Packard Bell reserves the right to make changes to the Vibe 100 MP3 player without
notice.
Technician Notes
Only technicians authorized by Packard Bell should attempt to repair this equipment. All
troubleshooting and repair procedures are detailed to allow only subassembly/module
level repair. Because of the complexity of the individual boards and subassemblies, no
one should attempt to make repairs at the component level or to make modifications to
any printed wiring board. Improper repairs can create a safety hazard. Any indication of
component replacement or printed wiring board modifications may void any warranty or
exchange allowances.
Disassembly Instructions
When disassembling the system unit, follow these general rules:
n Turn off the power and disconnect all cables and peripherals.
n Label all removed connectors. Note where the connector goes and in what
position it was installed.
n Do not disassemble the system into parts that are smaller than those specified
in the instructions.
Reassembly Instructions
Reassembly is the reverse of the disassembly process. Use care to ensure that all
cables and screws are returned to their proper positions. Check that no tools or any
loose parts have been left inside the player. Check that everything is properly installed
and tightened.
Required Tools
All disassembly procedures can be performed using the following tools:
n Philips (#1 bit) screwdriver.
n Small flat-bladed screwdriver or a small coin.