Oregon RM382P Clock Radio User Manual


 
EN
7
To use the projector remotely:
1. Make sure the projection unit has been fully charged
(see Power section).
2. Twist open the projection unit and press , the
projection beam should now be displayed.
3. Close the projection unit and twist until it clicks shut.
4. Twist the closed projection unit to adjust the focus.
NOTE Whenever you open the projection unit you will
need to adjust the focus of the projection once you have
closed it.
To change the projection angle:
Place the unit on 1 of the 3 flat circles on its base to
display the time vertically at 3 different angles.
TEMPERATURE
To change the indoor temperature unit on the display,
press °C / °F on the base of the main unit.
RESET
To return the unit to the default settings, insert a blunt
stylus into the RESET hole on the base of the main unit
or on the inside of the projection unit.
PRECAUTIONS
This unit is engineered to give you years of
satisfactory service if you handle it carefully. Here are
a few precautions:
Placement of this product on wood surfaces with
certain types of finishes, such as clear varnish, may
result in damage to the finish. Consult the furniture
manufacturer’s care instructions for direction as to
the types of objects that may safely be placed on
the wood surface. Oregon Scientific shall not be
responsible for any damage to wood surfaces from
contact with this product.
Do not cover the ventilation holes. Make sure
items that are nearby such as newspapers,
tablecloths, curtains etc cannot accidentally cover
the ventilation holes.
Do not immerse the unit in water. If you spill liquid
over it, dry it immediately with a soft, lint-free cloth.
Do not clean the unit with abrasive or corrosive
materials. This may scratch the plastic parts and
corrode the electronic circuit.
Do not subject the unit to excessive force, shock,
dust, temperature or humidity, which may result in
malfunction, shorter electronic life span, damaged
battery and distorted parts.
This product may malfunction if electrostatic
discharge or radio interference appears in the
environment and / or affects the ac power line. The
unit will revert to normal operation when interference
stops.
Do not tamper with the unit’s internal components.
Doing so will invalidate the warranty on the unit and
may cause unnecessary damage. The unit contains
no user-serviceable parts.
Only use fresh batteries as specified in the user’s
RM382P_M_EN_OP_REVISED1.indd 7 4/19/06 6:03:42 PM