Oregon RM382P Clock Radio User Manual


 
EN
6
1. Press ALARM to toggle between the alarm displays
and select either alarm 1 or 2, for setting.
2. Press and hold ALARM to enter alarm setting mode.
The alarm setting will blink.
3. Press / to change the settings. Press and
hold / to speed through values.
4. Press ALARM to confirm.
5. The setting sequence is: Hour and minute.
NOTE “-:--“ appears when the alarm is not activated.
The alarm icon will appear on the display to show which
alarm has been set:
ICON MEANING
/ Alarm 1 / alarm 2 is set
No icons No alarm is set
To activate / deactivate an alarm:
Press AL ON / OFF to toggle between alarm 1 and
2, both alarms ON or OFF.
OR
Press ALARM to select alarm 1 or 2 and then press
AL ON / OFF.
To silence the alarm:
Press SNOOZE, to silence it for 8 minutes. Press
ALARM or AL ON / OFF to turn it off during the 8-
minute snooze time.
OR
Press any key except SNOOZE to stop the alarm and
reset it to activate at the same time the next day.
NOTE When the snooze function is activated, the alarm
icon will flash.
PROJECTOR
When the projection unit is placed on the main unit it will
automatically recharge its batteries and synchronize its
time with the main unit.
To turn the projector ON / OFF when it is on the
main unit:
Press PROJECTION on the main unit.
ICON DESCRIPTION
The projection unit is out of
synch with main unit and is being
updated
The projection unit has just been
placed back on the main unit and
it is checking to see if it recognizes
the projection unit
The main unit
recognizes the
projection unit and
is charging it.
The main unit does not recognize
the projection unit. Adjust the
position of the projection unit until
the icon becomes animated.
icon
disappears
from display
RM382P_M_EN_OP_REVISED1.indd 6 4/19/06 6:03:42 PM