Filter
Top Products
5
PREPARATION
CONNECTING THE
SPEAKERS
Caution:
Do not plug in the power
cord until you connect the speakers.
Operating the CD-3329 without con-
nected speakers could damage it.
The wires for the CD-3329’s detach-
able speakers are rolled up in the re-
cessed area at the back of each
speaker.
Unwind the wire from each speaker,
then follow these steps to connect the
speakers to the system.
1. If you want to attach the speakers,
align the dovetails on the side of
the right speaker with the tracks
on the right end of the main sys-
tem and slide the speaker down
until it clicks into place.
Align the dovetails on the side of
the left speaker with the tracks on
the left end of the main system
and slide the speaker down until it
clicks into place.
2. Press the red speaker terminal tab
labeled
R +
on the back of the sys-
tem, insert the stripped end of the
right speaker’s stripped wire into
the terminal, then release the tab.
3. Press the black speaker terminal
tab labeled
R –
on the back of the
system, insert the stripped end of
the right speaker’s other wire into
the terminal, then release the tab.
4. Repeat Steps 3 and 4 to connect
the left speaker to the
L +
and
L –
terminals.
To disconnect the speakers from the
system, disconnect the speaker wires
from the CD-3329. Then (if speakers
are attached) hold down the main sys-
tem while you slide the speakers up-
ward along the tracks.
14-507.fm Page 5 Wednesday, June 30, 1999 12:01 PM