Filter
Top Products
14
PROGRAMMED PLAY
You can program up to 20 tracks from
the loaded CDs to play in any se-
quence.
1. Hold down
PROGRAM
until
PRO-
GRAM
,
CD 1
and
CD 2
flash.
2. Press
CD 1
or
CD 2
to select your
desired CD. Then press
SKIP |
or
SKIP
|
(
|
or
|
on the
remote) to find the track you want
to program.
3. When you reach the desired track,
press
PROGRAM
.
PROGRAM
,
CD
1
and
CD 2
flash again for you to
program the next track.
4. Repeat Steps 2–3 for each track
you want to program.
Notes:
• When 20 tracks are pro-
grammed,
PROGRAM
,
CD
1
and
CD
2
do not flash because you
cannot program any more
tracks. To change the pro-
grammed tracks, you must first
cancel the programmed
sequence (see “Deleting a Pro-
grammed Sequence”), then
program a new sequence.
• To check a programmed
sequence, press
SKIP |
(or
|
on the remote) repeatedly
to review the tracks.
5. Press
PLAY/PAUSE
(or
||
on the
remote). The CD player plays the
tracks in the order you pro-
grammed, then stops.
Notes:
•Press
PROGRAM
then
PLAY/
PAUSE
(or
||
on the remote) to
start playing the sequence again
from the beginning.
• You can press
SKIP |
or
SKIP
|
(
|
or
|
on the remote) to
move through the programmed
sequence during play.
Deleting a Programmed
Sequence
To delete the programmed sequence,
do any of the following:
• Open the CD compartment door.
• Set the switch to
RADIO
or
TAPE
.
•Press
CONTINUOUS PLAY
.
•Press
CD 1
or
CD 2
.
14-507.fm Page 14 Wednesday, June 30, 1999 12:01 PM