Filter
Top Products
83
7
Troubleshooting
Probable cause
The battery is not loaded properly.
The battery is dead.
The recorder is in HOLD mode.
The recorder is in HOLD mode.
The battery is dead.
Low remaining internal flash memory.
The maximum number of files has been
reached.
MUSIC mode is active.
The earphone is connected.
The VOL(+ or -) button is set to 0.
The file is locked.
The file is read-only.
The recorder was shaken during recording.
The recorder was placed near a cell phone
or fluorescent light while recording or
during playback.
The microphone sensitivity is too low.
The maximum number of index marks (16)
has been reached.
The file is locked.
The file is read-only.
The destination folder for downloading was
other than the Root folder or Music folder.
VOICE mode is active.
MUSIC mode is active.
Wrong folder.
Symptom
Nothing appears
on the display
Won’t start
Unable to record
No playback tone
heard
Unable to erase
Noise heard
during playback
Recording level
too low
Unable to set
index marks
Cannot find the
downloaded file
Cannot find the
recorded voice
Action
Verify polarity is correct.
Replace with new battery (☞ P.10).
Release the recorder from HOLD
(☞ P.11, 73).
Release the recorder from HOLD
(☞ P.11,73).
Replace with new battery (☞ P.10).
Erase unnecessary files (☞ P.70).
Check another folder.
Switch to VOICE mode (☞ P.14).
Unplug the earphones to use the
internal speaker.
Adjust the VOL(+ or -) button (☞ P.24).
Unlock the file (☞ P.34).
Cancel the read-only setting of the file on the PC.
Move the recorder.
Set the microphone sensitivity to “Conf”
mode and try again (☞ P.21).
Erase unnecessary index marks
(☞ P.32).
Unlock the file (☞ P.34).
Cancel the read-only setting of the file on the PC.
Copy the music file into the Root folder
or Music folder.
Switch to MUSIC mode (☞ P.14).
Switch to VOICE mode (☞ P.14).
Switch to the right folder.
Troubleshooting