Filter
Top Products
21
About Recording
2
Recording
e
d
5
Press the
STOP
4 button to stop
recording.
• [ ] will go out on the display.
e File length
Actually producing the sound you
would like to record:
• When a loud sound is produced the level
meter will swing all the way over to the right
while recording and the red [PEAK] indica-
tor lamp will turn on. When this happens
the sound will be recorded in a distorted
manner since the recording level is too
high.
When the level meter
is maxed out (the
recorded sounds will
be distorted)
Example of conditions
where the recording
level has been lowered
and the excess input
has been adjusted
• When a loud noise is produced, adjust
the recording level so that the level meter
remains in the vicinity of [–6].
4
Press the
REC
s button again will
begin recording.
• [ ] will appear on the display.
d Elapsed recording time
Notes
• When an SD Card is inserted in the recorder,
be sure to confirm the recording media as either
the [Built-in Memory] or the [SD Card] so that
there is no mistake (☞ P.34, P.39).
• When attempting to perform operations such as
rewriting the contents of an SD Card in cases
where the card has been write protected, [SD
Card Locked] will appear. The playback opera-
tion can be performed, but the write protection
must first be turned off when overwriting the
contents on the card (☞ P.15) .
• If you select a folder other than
A
through
E
and press the REC s button, an [Illegal
Folder] message will flash. Select a folder from
A
through
E
and start recording again.
• When remaining recording time is less than
60 seconds, the [PEAK] indicator light starts
flashing in amber. When the recording time
is decreasing to 30 or 10 seconds, the light
flashes faster.
• [Folder Full] will appear when the folder capac-
ity is full. Delete any unnecessary files before
recording any further (☞ P.32) .
• [Memory Full] will appear when the memory
is full. Change the recordable media or delete
any unnecessary files before recording any
further (☞ P.32, P.34, P.39).
• When the recording button of the exclusive
remote control RS30W (optional) is pressed
once, recording will start immediately.