Filter
Top Products
To install the player
1. Make sure that what kind of power system your car is. Please slide to “-” at the
left position if your Vehicle’s power supply system is negative;
Please slide to “+” at the right position if your vehicle’s power supply system is
positive.
Notes: 1.Please slide it to a side fully.
2. Do not slide this switch after Place it at a position. Otherwise, it’ll be
damaged.
2. To prevent short circuits, remove the key from the ignition and disconnect he
terminal of battery.
3. Disconnect the original dome light.
4. Attach the metal mounting plate to the roof Using the ST4.2*16 screws.
Note: Do not to cover the original dome light opening.
5. Pull out the original dome light Power wire and Signal/power Cable through
the original dome light opening.
6. Place the rubber on the player
7. Connect input and output cables.
8. Connect the wire harness in the following order: ground wire, battery wire,
ACC wire and door wire.
Six Screw ST4.2*16
12