Filter
Top Products
- 12
First installation
DVD menu
Language DVD Player Menu
Back
End
InfoAccept with OK
Deutsch D
English GB
Español E
Français F
Nederlands NL
Italiano I
Press the button OK .
The selected language is then set as Auro’s user interface
language.
The DVD menu is closed when you press the END button.
Activate Digital Link
With Digital Link, Loewe TVs pass on the remote control signals to Auro via the
Euro-AV connection. Digital Link is useful when you want to install Auro con-
cealed, e.g. in a closed rack where it cannot be reached by the remote control
signals.
Switching on Digital Link
Auro must be in standby (standby indicator lights red, display is dark). Hold the
button the device pressed for at least ve seconds until the message
LINK appears in the display.
Switching off Digital Link
Auro must be in standby (standby indicator lights red, display is dark). Hold the
button the device pressed for at least ve seconds until the message
FRONT appears in the display.
Switch over PAL/NTSC
Auro is set to the PAL TV norm at the factory. If your TV is set to another standard
(NTSC), you have to adapt the Auro setting accordingly. There is no disc in the
drive and the drawer is closed.
If Auro is switched on: keep the Pause button on the device
or on the remote control pressed for ve seconds.
NTSC, appears in the device display, Auro is then set to the NTSC TV standard.
In the same way, you can set the Auro to AUTO or PAL.
In the AUTO AUTO setting, Auro automatically detects whether a PAL or an
NTSC-DVD is inserted and switches over to the respective standard.
Doing a reset
You can reset all settings in Auro to their original values with a Reset.
The state prior to initial installation (Factory Setting) is reinstated.
If Auro is in standby mode (red standby indicator lights) and the remote control
is set to the DVD/CD mode:
Press the button on the remote control and hold it down.
Also press the button on the device and hold it down.
Keep both the buttons held down for at least 5 seconds.
Then, Auro switches on, the message RESET appears in the display. The
sub-device DVD/CD is active.
All settings are therefore reset to their original values. You have to perform initial
installation.
Switching over to Progressive Scan
With the Progressive Scan mode you get the highest possible picture quality
without ickering in the “Component Video” operating mode. Set the “VIDEO
OUT SELECTOR“ switch on the back of Auro to the “COMP“ position. If Auro is
switched on: Keep the stop button (there is no disc in the drive and the drawer is
closed. / no menu display) on the unit pressed for ve seconds.
P-SCAN ON, appears in the unit display so that Auro is switched to Pro-
gressive Scan mode.
In the same way you can set Auro to P-SCAN OFF.
1.
2.
3.