Filter
Top Products
IB-PDV709-WM-E-061006
REMOTE CONTROL OPERATION
8
NOTE:
•
Point the remote control unit from less than 20 feet (6 m) from the remote sensor and within
about 60
o
of the front of the unit.
•
Batteries should be changed by an adult for safety.
•
Reversing polarities will damage the batteries and possibly your remote. Be sure to follow
polarities ( + and –) as indicated.
•
Do not mix different types of batteries together (Alkaline, Carbon-Zinc, Nickel-Cadmium
etc.), or old batteries with new ones.
•
When the batteries have become discharged,they must be disposed of in a safe manner that
complies with all applicable laws.
•
When the batteries becomes weak, the operating distance of the remote control decreases
and you will need to replace the batteries.
•
When the remote control is not to be used for a long time (2 months or more), remove the
batteries to avoid possible damage that may be caused by battery leakage.
•
Avoid keeping the remote control in extremely hot or
humid locations.
•
Do not point bright lights at the remote control sensor (like laser pointers).
•
Do not place objects between the remote control unit and the remote control sensor.
•
Do not use this remote control while using the remote control unit of any other equipment at
the same time, the signals may mix.
Working conditions and precautions for the rechargeable battery
•
New batteries should be fully charged before initial use (about 5 hours).
•
Battery should be changed by an adult for safety.
•
Battery should only be used and charged when temperatures are between 32 -100
O
F.
•
Never put the battery in fire or water.
•
Do not expose the battery to high temperatures or store in hot, sunny places.
•
Do not short the battery terminals.
•
Do not open the battery.
•
When the battery is weak, the ON/STANDBY indicator will flash and the Low Power icon
“ ” will appear on the LCD screen and then the power automatically turns off. If this
occurs, please use the AC adaptor to recharge the battery or play the set on AC power.
1.Push the tab to open the battery cover.
2.Insert 2 size “AAA” alkaline batteries
(included) into the battery compartment
according to the + and – markings
inside the battery compartment, then
replace the battery cover.
NOTE: When inserting the battery while the set is AC powered or car powered, there will be a
delay of several seconds before the LED lights up. This is because the battery charging
circuit needs to reset and detect the battery status.
2.The battery LED indicator will flash when the battery is charging and remain steadily on
when the battery is fully charged.
3.Charging time is about 5 hours. A fully charged battery delivers about 2.5 hours of viewing time.
4. To charge the battery using the supplied car adaptor, follow point B on the previous page.
IB-PDV709-WM-E-061006.pmd 8/3/2006, 11:00 AM9