IB-PDV709-WM-E-061006
S
L
I
D
E
2
3
POWER SUPPLY
C. Using the rechargeable battery
The rechargeable battery pack is suitable for portable use which allows you to enjoy the
unique functions of this unit outdoors.
Remember to charge the battery fully before
initial use (about 5 hours).
You can power this portable DVD player by connecting the AC adaptor, the car adaptor or the
rechargeable battery (all included).
A. Using the AC adaptor
This player is supplied with an AC adaptor for powering the
unit and charging the battery.
Insert the AC adaptor plug to the DC IN jack on the portable
DVD player and connect the adaptor to a wall outlet.
Attaching the Battery (refer to the diagram on the right)
1.Make sure the player is off and the AC adaptor or car adaptor is
disconnected.
Detaching the Battery (refer to the diagram on the right)
1.Make sure the player is off and the AC adaptor or car
adaptor is disconnected.
2.Push the tab on the battery down.
3.Slide and lift the battery out.
7
tab
B. Using the car adaptor (12V)
Insert the car adaptor plug to the DC IN jack on the
portable DVD player and connect the car adaptor
to the vehicle’s 12V accessory / cigarette lighter
socket, the car adaptor indicator will light up.
CAUTION:
1.The included car adaptor is for use with this unit only. Do not use it with other equipment.
2. Use this unit only with the included car adaptor, using with other car adaptors could damage
the unit and the unit may not work.
3.Do not operate this unit or view video movies while driving a vehicle.
4. If some lines appear on the screen during the startup of the vehicle, please turn the unit off
and turn it on again after the vehicle is running.
5.Place the unit in a proper position for viewing.
6.When the inside of the cigarette lighter socket is dirty with ashes or dust, the plug section may
become hot or not work due to poor contact. Be sure to clean the cigarette lighter socket before use.
7.Disconnect the car adaptor from both the unit and the cigarette lighter socket when the
battery is fully charged and the unit is not in use.
To charge the battery
1.Insert the AC adaptor’s plug into the DC IN jack on the DVD player and connect the AC
adaptor to a wall outlet. After 5 seconds, the battery LED indicator will turn on and start to flash.
This player is supplied with a 12V car adaptor for powering
the unit and recharging the battery while in a vehicle that
has a 12V power system.
slot
2.Place the DVD player on a soft and smooth surface with the bottom
of the unit facing up.
3.With one hand on the DVD player to prevent it from moving, take the
battery and align the plastic tabs on the battery with slots on the
player, and slide it forward to lock, The battery will click into place.
IB-PDV709-WM-E-061006.pmd 8/3/2006, 11:00 AM8