Filter
Top Products
17
- Touch the "ENTER" field, the display is:
SENSOR NO 1 ADD DEL
- Repeatedly touch the "SENSOR" field and select the memory slot where you want
to store the particular sensor. Please note that TX 550 US can only be stored in
slot 9.
- Then select "ADD"; the display is (for e.g. for sensor 9: TX 550 US):
SENSOR NO 9 - - SYNC ADD DEL
- The particular sensor is now taught to the system. Insert the batteries in the
respective sensor and press its key to teach. Please also read chapter 2.2 for
starting up TX 550 US and the operating instructions of the other sensor types.
The TX 550 US data is then displayed automatically (after max. 6 minutes) in the
corresponding fields of the display - that of the remaining sensors after selecting
the memory slot ("sensor" field) in the "OUTDOOR" display field.
Marking the populated memory slots
Memory slots that have already been populated are marked as "USED" behind
the memory slot number.
However, this does not indicate whether the respective sensor is actually active.
You can identify it only from the missing or outdated data when you select the
sensor and from the active reception indicator in the "OUTDOOR" field.
Deleting a sensor assignment
The serial number of a sensor can be deleted from the sensor memory, if re-
quired.
- First proceed according to the instructions given under "Logging in"; select the
desired sensor and then select the "DEL" option instead of the "ADD" option.
- The "USED" lettering of the sensor number is deleted and the memory slot is thus
released again for logging in a sensor.
Tip for initial senor set-up
To ensure proper set-up, please have the sensors and the receiving station 3 to 5 feet
apart. Note: The distance should not be less than 3 feet (1 m) apart.