Filter
Top Products
7
Power Supply
Preparations
Using the AC adaptor
Connect the AC adaptor supplied.
a DC IN jack (DC IN 4.5 V )
b Right side panel of the unit
c AC adaptor
d AC power outlet
Note:
The unit is in the standby condition when the AC adaptor
is connected. The primary circuit is always “live” as long
as the AC adaptor is connected to an AC power outlet.
Using dry-cell batteries
(not included)
After disconnecting the AC adaptor, insert two “R6” (LR6)
alkaline batteries.
The procedure for inserting and removing dry-cell bat-
teries is identical to that for rechargeable batteries.
Using external battery case
Open the battery cover of the external battery case (sup-
plied) and insert two “R6” (LR6) alkaline batteries (not
included) into the battery compartment. Then, install
the external battery case in the unit by turning the knob
of the battery case.
e Bottom of the unit
Battery indicator
f Battery indicator
This indicator lights when the batteries are almost out of
power. Power is shut off a short while later.
Rechargeable batteries: Recharge batteries.
Dry-cell batteries: Replace batteries with new ones.
Notes:
• The length of time the unit can continue further opera-
tion after the battery indicator lights differs depending
on the type of batteries used.
• The battery indicator may not light if rechargeable bat-
teries, other than those designated by JVC, are used.
Tip:
Turning off the Anti-Shock Protection (see page 29) will
save the battery power more or less. (Available for an Au-
dio CD only)
If the unit malfunctions or freezes during use,
disconnect the AC adaptor and batteries. Then,
connect the AC adaptor and batteries, and op-
erate the unit again.
XL-PM30(en,sp,du)p01-18.p65 2002.06.18, 13:447