Filter
Top Products
Page 10
XL-MV777GD/XL-MV757TN
LVT0194-001B [U, US]
Selecting the Dolby Surround mode
You can enjoy the surround sound with discs bearing the mark
.
Preparation
• If your system is ready for the Dolby Pro Logic, make the connection
between the player and your amplifier/receiver correctly according
to “Basic connections” on page 2.
• Even if your audio system is for a normal stereo reproduction,
including a stereo amplifier/receiver and two speakers, you can
enjoy the pseudo-surround sound with 3D Phonic mode.
Operation
To select the Dolby Surround mode, use the DOLBY SURROUND
button. Pressing this button cycles the modes as shown below.
NORMAL
(Pro Logic)
WIDE
(Pro Logic)
PHANTOM
(Pro Logic)
OFF 3D Phonic 3 STEREO
When any mode but OFF is selected, the DOLBY SURROUND
button lights.
Select the mode depending on your system configuration.
NORMAL (Pro Logic):
Select this mode when the center speaker cannot reproduce the
bass better than the front speakers. The bass portions of the
center channel signals are output through the front speakers.
WIDE (Pro Logic):
Select this mode when the center speaker can reproduce the
bass better than the front speakers. All signals of the center
channel are output through the center speaker.
PHANTOM (Pro Logic):
Select this mode when you do not use a center speaker. The
center speaker channel signals are output through the front
speakers.
3 STEREO:
Select this mode when a center speaker is connected without
rear speakers.
3D Phonic:
Select this mode when reproducing the surround sound with
only two front speakers. It gives you very realistic surround
effect as if the sound is reproduced through the Dolby Sur-
round decoder.
This mode is the result of research on sound localization
technology carried out at JVC for many years and make it
possible to reproduce the surround sound with only two front
speakers.
* Manufactured under license from Dolby Laboratories. "Dolby", "Pro Logic",
and the double-D symbol are trademarks of Dolby Laboratories.
BASIC OPERATIONS
To adjust the output balance of speakers
1. Set the Dolby Surround mode to any one of NORMAL, WIDE,
PHANTOM and 3 STEREO.
2. In stop mode, press the SUBTITLE button on the player
repeatedly until the following display apears on the television
screen.
The test tone is output from speakers in the following order.
Front-left
(L CH)
Center
(C CH)
Front-right
(R CH)
Rear
(S CH)
See whether you hear the test tone from each speaker in the
same level at the listening position.
3. If any adjustment is necessary, press the DOLBY SURROUND
button to select the channel (CENTER or SURROUND) to be
adjusted.
The selected channel turns yellow.
4. Each press of the UP ( # ) button on the player or remote control
unit increases the output level up to +10 dB.
Each press of the DOWN ( ) button on the player or remote
control unit decreases the output level up to -10 dB.
5. Pressing the SUBTITLE button on the player or remote control
unit completes the adjustment.
The setting is memorized and will not disappear even if the player turns
to the standby mode or completely off.
When setting the Dolby Surround mode to PHANTOM, CENTER
cannot be adjusted.
When setting the Dolby Surround mode to 3 STEREO, SURROUND
cannot be adjusted.
(Television screen)
The channel from which the
test tone is output
Output level
CENTER / SURROUND CH
LEVEL ADJUSTMENT
TEST TONE
CENTER
SURROND
L
CH
CH
CH
0
0
PROGRAMMED SONGS