Filter
Top Products
A6826A PCI-X host bus adapter for Itanium Linux systems installation guide 17
Using fibreutils RPM
HP recommends using the fibreutils utility that is installed by the driver kit. It contains useful utilities
for managing fibre-attached storage. To manually install this RPM, enter the following command:
# rpm -ivh fibreutils-<version>.rpm
For more information about fibreutils, see the file /opt/hp/hp_fibreutils/README.
Changing driver parameters
To change driver parameters:
1. Run the set_parm script located in the /opt/hp/src… directory.
2. Reboot the system.
NOTE: You may not be able to unload the qla2200 and/or qla2300 modules if there is a process
or file system using a device that is attached to the A6826A HBA.
Installing the driver on the boot drive
NOTE: The following instructions for installing the driver and loading and unloading the driver are
required only if the driver has been built from source. If the driver was installed from an RPM or
driver kit, the driver loads at boot time.
Before installing the driver, note the following:
• The A6826A HBA must be installed in the system before installing the qla2300 driver.
• The <kernel_release_version> is the Linux kernel release version of your system.
• In the following example, the path to your driver may be:
/lib/modules/<kernel_release_version>/kernel/drivers/addon/…