Filter
Top Products
Quickstart
FS-C Portable DTE Recorder 23
Connecting a FS-C to a DV/HD Camcorder
Before performing this procedure, make sure you have
installed and charged the battery, see
Installing / Removing the
Battery Pack
on page 21.
1. Connect the supplied Firewire cable to the “DV I/O” connector
on the top of the FS-C.
2. Locate the FireWire/DV/iLink (or similar) connector on your
video camera. It is located in different places depending upon the
brand of camera. If you are unclear of its location, consult your
video camera manual.
3. Connect the other end of the FireWire, 1394, cable to your video
camera.
4. Turn on the video camera.
5. Turn on the FS-C.
FS-C Supplied with 4-pin to 6-pin FireWire Cable
A 4-pin to 6-pin FireWire, 1394, cable is provided with the
FS-C.
FireWire Connector
The FireWire connector on the XL H1 is located on the back side of the
camera, above the XLR connectors. On the XHG1 and XHA1 cameras the
firewire connector is located on the back to the right of the battery
compartment.
For more information, refer to the Canon HDV camcorder’s documentation.
IEEE 1394 Cable
4-pin to 6-pin