Filter
Top Products
66
Take note of the following advice in order to prevent malfunction and damage.
• Use and store this unit within the operating tem-
perature range and storage temperature range
as specified in this manual.
• Do not install the unit in a place prone to vibra-
tion or shock.
• Do not install the unit close to television, radio or
video equipment that generates magnetic fields.
This may have a negative effect when projecting the
playback of audio and video with this unit, and may
cause this unit to malfunction. In the event that such
symptoms occur, move the unit further away from
any television, radio and video equipment.
• Do not install this machine on an incline.
• Do not move this unit during playback.
This may damage the disc or cause malfunction.
• Avoid using or storing this unit in cigarette or
other smoke filled places, or in rooms containing
a large amount of dust.
This may cause degradation of the image quality.
• Do not touch the projection lens with your bare
hands.
If fingerprints or marks are left on the face of the
lens, the image will not be projected clearly. Make
sure the lens cover is securely in place when not in
use.
• Epson will not be held responsible for damage
arising from projector or lamp failure outside the
range of that which is covered in your warranty
terms.
If you move this unit from a cold place into a warm
room, or, if the room in which this unit is installed is
heated rapidly, condensation (moisture) may form
internally or on the lens surface. If condensation forms,
it may not only cause incorrect operation such as weak-
ening of the image, but also damage the disc and/or
parts. In order to prevent against condensation, set up
this unit in the room approximately one hour before it
is to be used. If by some chance condensation does
form, turn on the main power switch then wait 1-2
hours before use. Do not use the lamp during this time.
This product includes a lamp component that contains
mercury. Please consult your state and local regulations
regarding disposal or recycling. Do not put in the trash.
MovieMate uses a mercury lamp with a high internal
pressure as its light source. Mercury lamps have the
following characteristics.
• Lamp brightness decreases once the rated lamp usage
time has passed.
• When the lamp reaches the end of its life, it may enter
a state where it will no longer light, or it may explode
with a loud noise due to impact, deterioration, or the
expiration of its usage time.
• Depending on the individual difference of each lamp
and the conditions of use, there is a considerable
difference in the time it takes for the lamp to reach the
end of its life. Make sure you have a replacement lamp
available.
• The potential for the lamp to explode increases once
the lamp usage time has been exceeded.
When the lamp replacement message appears,
promptly replace the lamp with a new one.
• Although the liquid crystal panel is made using very
precise high technology, you may see some black
pixels, or pixels that are always lit red, blue, or
green.You may also be able to see lines with irregular
brightness or color.
These are normal characteristics of liquid crystal
panels, and are not indicative of any malfunction. Be
aware of this fact.
Use and Storage
Notes on handling and storage
Condensation
Lamp
LCD panel