Filter
Top Products
38
Next Generation:
Our next generation recorders such as the HAWK/4, HAWK8, FALCON/4 use a
black switch that slides into designated modes "ON" and "OFF
If the remote record switch is attached to the RECORDER it must be used for
ON/OFF control. When the red slide switch is slid to the “ON” position a black
dot appears and the recorder begins recording. For special applications, ADS
also makes a set of external microphones without the external ON/OFF switch.
NOTE!
To ensure proper operation,
depress all switches for about 2 seconds.
RCD/ON
The "RCD red button “or “ON black slide switch " activates the HAWK to go into
the record mode. The LED turns red, then green within 2 seconds to indicate
that the camera is attached. The LED will flash “red” following incoming audio
while the unit is recording.
NOTE!
The user should make a short “preamble” recording to check that
everything is attached and working properly. Make sure the red and green
LEDS are present, if they are not, go to the nearest computer and make
sure the memory has been erased and the batteries are new.
NOTE!
If you are in PLAY mode, you must turn the unit "OFF" before you can enter
the RECORD mode. During PLAY the RCD switch acts as the "FWD".
STOP/OFF
The "STOP red button " or “the OFF black switch” halts recording, and puts the
unit in a low power state. The RECORDER logs the states of ”ON / OFF” and the
date/time as “Session” information.
PLAYBACK