Filter
Top Products
10
Figure 2.2.1 ENABLED / SET TIMERS
2. At the TIMER RECORDING START DATE / TIME the TIME is in military
(24 Hour) format. Enter the date under TIMER RECORDING START
DATE. A calendar appears. Enter the time in the TIME section. The
TIME activates the recorder. Refer to Figure 2.2.2, Timer Mode Entry
3. Next enter the ”RECORD TIME,” the RECORD TIME keeps track of the
record length. Once RECORD TIME has completed the RECORDER
turns off. Refer to Figure 2.2.2, Timer Mode Entry
4. Set the IDLE TIME, it brings the RECORDER into hibernation mode.
Once hibernation time has completed the RECORDER will be reactivated.
If the RECORDER has no hibernation time, do not set IDLE TIME. Refer
to Figure 2.2.2, Timer Mode Entry
5. Select the RUN count, the number of times the RECORD TIME AND IDLE
TIME occur. (1= One Time) Selecting CONTINUOUSLY sets the
RECORDER to go through the RECORD TIME and IDLE TIME until
memory is full. Refer to Figure 2.2.2, Timer Mode Entry
6. Select “OK” to save settings and go back to the SETUP menu.
Refer to Figure 2.2.2, Timer Mode Entry
7. When you return to the SETUP menu don’t forget to “APPLY
CHANGES” thus the new settings are saved.
8. Note the “ TIMER MODE” indication on top right of the screen in
CURRENT RECORDER SETTINGS.