Filter
Top Products
39
The playback function uses all 4 switches. NOTE that you must be in the OFF
state to re-enter the record mode. The REW and FWD switches have different
meaning when in PLAY or PAUSE. Note that “playback” does not erase any
data. Once you are finished with local “playback”, you may continue recording
from where you left off by first turning the RECORDER “off” then pressing RCD.
The HAWK8/A and FALCON4 do not have PLAYBACK capability.
PLAY / PAUSE
NOTE!
The Play / PAUSE (P/P) as well as the REW(R) controls on the HAWK unit is
on the bottom. Use a paper clip to operate and hold down button until
recording plays (3-5 seconds).
The "PLAY" button causes the unit to power up, turn the green LED 'ON" and
start playing from the beginning Session 1. Depressing this switch while the unit
is playing will cause it to PAUSE and flash the green LED. To continue playing
you must depress this switch again.
REW
Depressing this switch while the audio is playing causes a 3-minute jump back.
Depressing it while you are in PAUSE causes the RECORDER to begin playing
from the beginning of the current Session. To jump back into the previous
session you should hit REW from the PAUSE state, and then hit REW again to
take you back into the previous session.
FWD
Depressing the "FWD" switch causes the audio to jump ahead 3 minutes. If you are in
the PAUSE state, depressing this switch will jump you into the beginning of the next
Session.
OFF
Depressing this button will cause the recorded to be powered OFF. This must be
done to re-enter the RECORD mode.
RECORDING LENGTH
Type of camera and frames per second determines the recording length. The
chart below displays HAWK recording duration. The settings are stereo with 2:1
compression. Times are given for each session and full recorder length.