Filter
Top Products
36
If the battery is low then the LED will flash ON and OFF slowly.
No red or green LED present the record is not recording.
NOTE!
If the low battery indicator is flashing, turn the unit “OFF” replace the cells
and turn the unit ON or “RCD” again.
The computer will display the fact that the “last recording” was stopped short
because of a low battery condition.
The green "LED", further back, will be ON when the unit is in playback. In later
software releases the LED will follow the playback audio levels.
CAMERA
The HAWK has a variety of camera options. You can have a black and white or
color camera. The image sizes are (LOW resolution) 352 X 288 and (HIGH
resolution) 640 X 480 pixels. The VGA camera can operate both HIGH (640 X
480) and LOW (352 X 288) RESOLUTION MODE. The selection can be made
from “SETUP.”
The MICROCAM operates at 640 X 480. (High Resolution)
The HI-RES CAM operates at 1280 X 960 1.3 MEGAPIXEL
Dual Cameras have the advantage of two cameras, for applications that need
more than one camera angle.
Once the camera is connected and the unit is turned ON, the HAWK will
automatically detect and recognize which camera is used and adjusts the
parameters accordingly. Refer to Figure 6-2 HAWK with HAWKEYE (shirt
button), HCAM (pinhole) and the adjustable lens cameras.
NOTE!
If no camera is found the LED will not turn “GREEN”, hence you should turn the
unit “off” wait 5 seconds and try again. The HAWK will record “audio” if the
camera does not operate.
CAMERA DEFINITIONS
At the end of each camera connector there is a stripe that distinguishes the color
and type of the camera.