Filter
Top Products
7
OPERATING INSTRUCTIONS
NORMAL PLAYBACK
1. Connect the headphones to the PHONES jack.
Set the VOLUME control to a low level before
you begin playback and then adjust the volume
to a comfortable level after playback begins.
2. Slide the CD Door OPEN switch to the right to
release the lock and open the CD Door.
3. Place your disc on the center spindle with the
printed label side facing up. Press down gently near
the center hole to make sure the disc is properly
seated on the spindle.
4. Close the door completely until it locks shut.
5. Press the PLAY/PAUSE button. “45 sec”
followed by “00” appear in the display as the player
reads the disc, then playback begins on Track 1.
The Anti-Skip indicator comes on and the playing
time shows in the display.
6. Adjust the VOLUME and DBBS (Bass Boost)
controls as desired.
NOTE: We have included a second volume
control on the headphone cable. This allows you
to easily adjust the volume if you are carrying the
main unit in a pocket, handbag, backpack etc.
7. When all tracks have been played the player stops
and the display shows the total tracks and playing
time on the disc. After approximately 1 minute the
power shuts off and the display goes blank.
To stop playback before the disc ends press the
STOP button at any time. Press the STOP
button again to shut the power off immediately.
8. Slide the CD Door OPEN switch to the right to
open the door and remove your disc. Close the
CD Door and return your disc to its protective
storage case.
VOL.
ON
BASS
OFF
To PHONES Jack
HD2850_ib.p65 8/10/01, PM 03:497