Filter
Top Products
15
ALARM OPERATION
You may set either or both alarms to wake you to the radio or an electronic buzzer
tone. The procedure for both alarms is the same.
1.) First depress either the ALM 1or ALM 2 buttons and verify that the wake up
times and the Alarm Mode settings are correct. Adjust if necessary.
See “SETTING THE WAKE UP TIMES”.
2.) Slide either the ALARM 1 or ALARM 2 selector switches from the ‘OFF’ position
to the ‘BUZZER’ or ‘RADIO’ positions. The ALM 1 and/or ALM 2 indicators on
the front panel will turn ‘On’ to confirm that the alarms are activated.
3.) If you selected ‘wake to radio’ turn the radio ‘On’, select the station that you
wish to hear and adjust the volume control to the desired wake up level, then
turn the radio ‘Off’ again.
4.) At the selected wake up time the unit will turn on and either the radio or the
buzzer will wake you up. The buzzer will continue for 5 minutes and then shut
off automatically and reset itself for the following day. The radio will play for
one hour and then stop and reset itself for the following day. To stop the radio
or buzzer sooner, press the ALM 1 or ALM 2 button. The alarm stops
immediately and resets for the following day.
5.) To cancel the alarm completely slide the ALARM 1 or ALARM 2 selector back
to the ‘OFF’ position. The ALM 1 and ALM 2 indicators turn ‘Off’.
SNOOZE / REPEAT ALARM
After the alarm comes on you may press the SNOOZE/SLEEP OFF bar to stop
the alarm temporarily. The alarm stops for approximately 9 minutes and then comes
‘On’ again.
CKA1100_drafts052102.p65 21/5/2002, 15:1915