Filter
Top Products
12
Manual Time Setting
If the receiver fails to detect the WWVB signal after several tries and you do not
want to wait until the reception condition improves, you may also set the time
manually as follows:
1.) Set the display to the correct year. Depress the DATE/MONTH and TIME
buttons together. The Month/Date display will show the initial default year of
2001. Continue to press the DATE/MONTH and TIME buttons and press the
“+” button to advance the year display to the correct year.
2.) Set the display to the correct month and date. Depress the DATE/MONTH
button. The month/date display will show the initial default month and date of
January 1
st
( 1 01). Continue to press the DATE/MONTH button and press the
“+” (or “–”) buttons to advance the month/date display to the correct setting.
The Day indicator will change automatically to match the month/date display.
You do not adjust the Day display separately.
3.) Set the display to the correct time. Depress the TIME/SECONDS button and
the “+” or “–” buttons to move the display forward or backward to the correct
time. The display changes slowly at first and then begins to change rapidly. If
you pass the correct time simply press the “+” or “–” buttons to back up to the
correct setting.
Notes:
• Be sure to observe the AM indicator to make sure you have set the time correctly.
If the AM indicator is ‘On’ the time displayed is “AM”. If the AM indicator is ‘Off’
the time displayed is “PM”.
• After setting the time recheck the month/date display. If you advanced the time
past midnight (12:00 AM) the month/date display will change. Re-adjust the
month/date display if necessary.
CKA1100_drafts052102.p65 21/5/2002, 15:1912