Filter
Top Products
VORSICHT: Von einer falsch eingesetzten Batterie geht Gefahr aus. Ersetzen Sie Batterien nur
mit dem gleiche oder gleichwertigen Typ. Diese gilt für alle Lautsprecher mit Batterien.
WARNUNG: Um Feuer oder einen elektrischen Schlag zu vermeiden, setzen Sie das Gerät weder Regen noch
Feuchtigkeit aus. Vermeiden Sie, dass Tropfen oder Spritzer an das Gerät gelangn. Stellen Sie keine mit
Flüssigkeiten gefüllten Behälter wie z.B. Trinkgläser auf das Gerät.
GEFAHR: Dieses Produkt ist so lange im Betriebszustand, wie Netzspannung anliegt.
GEFAHR: Lassen Sie mindestens 15 cm Freiraum um den Kühlkörper, damit die Luf
ungehindert zirkulieren kann.
1.2 EC Declaration of Conformity
Eastern Acoustic Works, as the manufacturer, hereby certifies that, in their delivered versions,
all un-powered (passive) loudspeakers comply with the provisions of the directives and
standards listed below.
European Council Directive on Low Voltage, 73/23/EEC
EN 60065:2002 Audio, video, and similar electronic apparatus - safety requirements
European Council Directive on Electromagnetic Compatibility 89/336/EEC
EN 50081-1:1992 Emissions limit for residential, commercial, and light industrial equipment
(generic standard)
EN 50082-1:1997 Immunity requirements for residential, commercial, and light industrial
equipment (generic standard)
The Technical Report/File is maintained at:
LOUD Technologies Inc. Worldwide Headquarters
16220 Wood-Red Road NE
Woodinville, WA 98072 USA
Tel: +1 425 892 6500
Tel: +1 866 858 5832
Fax: +1 425 487 4337
e-mail: info@eaw.com
Authorized Representative:
Kevin Cyrus
Loud Technologies, Inc.
Issued: 25 July 2005
NOTE: EC Declaration of Conformity for powered loudspeakers is found in their
accompanying owner's manuals.
1.3 Rigging: Mounting / Suspension
DANGER: Mounting or overhead suspension of any heavy load can result in serious injury
and equipment damage. This work should be done by qualified persons following safe rigging
practices in accordance with all applicable safety and construction standards. Such persons
must determine the required load ratings and design factors. They must determine the
mounting or suspension method that meets static, dynamic, shock, and any other load
requirements. All such work must be done in accordance with and in compliance with all
federal, state, and local regulations governing such work.
x