Filter
Top Products
FLUSH MOUNTING INTO MOUNTED PANELS
Step 1: Determine the tweeter mounting location, then route the
wires from the crossover to the tweeter location.
Step 2: Mark the center point of the tweeter location.
Step 3: If using a hole saw, first drill a pilot hole, then cut out the
hole using a standard 2-1/8" hole saw.
Step 4: If not using a hole saw, use either the cardboard packaging
for the tweeters or the surface mount trim ring as a template
to mark the proper size hole. Cut out the hole.
Step 5: Remove the tweeter from the flush mount housing and
insert the proper length machine bolt through the center
hole of the housing and connect to the spring steel X-
bracket. (See Figure 3.)
Step 6: Connect the speaker wires observing the correct polarity.
Step 7: Press the X-bracket portion of the assembly through the
hole until its legs spring open.
WIRING HARNESS
TRIM RING
FLUSH MOUNT
HOUSING
TWEETER WIRE
7